NOTE:
• Max. operation time: With heavy mixtures, do not operate the machine for more
than six minutes, and then allow it to cool down for a further ten minutes.
• Always begin mixing at a low speed, then increase to a high speed to prevent
splattering.
TROUBLESHOOTING
Problem
The machine doesn't
work
Noise in the mixing
bowl when working (the
accessory scraped the
bowl)
The bowl cover doesn't
fit the mixing bowl
properly
The machine doesn't
work on certain speed
Movements when the
machine working
The rise button didn't
spring back in place
after installing the
mixing bowl and pot
cover
CLEANING
• Before cleaning, make sure the appliance has been unplugged from the power
supply.
• Never immerse the appliance into any liquid.
• Hand wash the Dough Hook, Beater, Whisk and mixing bowl in warm soapy
water with a soft cloth after each use. Rinse and dry thoroughly. The Die-casting
Aluminium Dough Hook and Beater are not dishwasher safe.
• Clean the housing of the appliance with a damp cloth only.
• Do not expose them to heat or caustic cleaner. If so, they might become
misshapen or discolored.
• Do not use any sharp or abrasive detergents.
WKSMX1503_Stand Mixer_10L_IB.indd 7
• Check if the plug is in good contact with the socket.
• Check if the rise button spring back in place.
• Check if the machine works continuously more than
10 minutes, and wait until the motor cool down.
• Check if the mixing bowl is properly installed.
• Check if the accessory installed properly on
machine.
• Check if the bowl cover placed on the machine
properly.
• Check if the mixing bowl installed properly on
machine and locked correctly.
• Check if the mark on speed knob correspond to the
speed silkscreen on housing.
• Rotate speed knob to 0 ,and re-check if the
machine works.
• Check if the anti-slip feet fall off.
• Check if the machine is placed on a smooth and flat
tabletop.
• Check if the pot cover placed on the machine
properly.
• Check if the mixing bowl is properly installed.
Solution
EN
7
10/5/2021 16:02:55