Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly / operation
The brackets are mounted with the covering either detached (CASTELLO Pro,
PALAZZO Style/Noblesse) or attached (PALAZZO Royal) and with the parasol
half open. The rain gutter and side wall can only be fitted when the parasols are
fully open. Before closing the parasols, both rain gutters and side wall must be
removed. By adjusting the inclination of the rain gutter using the
straps, the water run-off can be optimised.
* only CASTELLO Pro
** only PALAZZO Style / Noblesse
2.1
when...
when...
2.3
*
2.4
**
1
Half open parasols.
!
In order to minimise the tension on
the covering...
2
Assembling the brackets
1. * Loosen the fixing screw of the
*
covering and raise the covering.
** Press in pin on endpiece from
above with a small screwdriver
and unlock / remove endpiece.
2. Push the brackets (correctly orient-
ed) over the strut (PALAZZO Royal:
**
push on).
3. Position the brackets at the same
distance from the edge of the roof
and clamp them in place with the
Allen screw.
4. * Lower the covering and fix it again
with the fixing screw.
** Mount / snap in endpiece.
5. Repeat steps 1 to 4 for each strut
affected.
!
The brackets must finally be in line
so that a good overlap between the
roof edge and the gutter remains. Tip:
loosen the covering only at one strut
at a time and attach the brackets strut
by strut.
3
Open parasols completely.
!
To assemble the rain gutter / side
wall, the parasols must be fully
open.
18
19
4.1
4.2
*
4.3
4.2
5.2
5.3
Disassembly
Before closing the parasols, the attached rain gutter / side wall must be
removed. To do this, detach them from the brackets. If necessary, pull out
the support tubes and disassemble them into the individual segments by
pulling them apart.
Care and maintenance
• Roll up windshield for storage, do not fold..
• Allow the rain gutter / side wall to dry when open, to prevent the forma-
tion of mould and discolouration.
• If necessary, clean the rain gutter / side wall with lukewarm water, mild
detergent and a sponge.
• Do not use bleach or sharp objects, to avoid damage to the rain gutter /
side wall.
• If the rain gutter / side wall is used in a highly exposed location, in-
creased wear must be expected. In such cases, we recommend more
intensive care and maintenance.
• Generally speaking a defective rain gutter and/or side wall can be re-
paired by your Glatz partner. Use only original replacement parts from
Glatz.
4
Preparing the rain gutter / side
wall
1. Hook the rain gutter / side wall into
the brackets on one side.
2. Put the upper and lower support
4.4
tubes together and push them into
the tube pockets.
3. Only for rain gutter: Put the middle
*
support tubes together and push it
4.4
into the tube pocket.
4. Close Velcro fastenings.
4.4
*only for rain gutter
5
Hang the gutter.
1. Hook the rain gutter into the brackets
5.1
on the adjacent parasol.
2. Level the rain gutter evenly to the
conical shape using the straps*.
3. Put the straps together between the
5.2
tubes and tighten them slightly
!
* Pull on straps to raise, press buckle
button to lower.
Publicidad
