Halo GFLS15FSUNVDBZK Instrucciones página 3

ENGLISH
INSTALLATION
1. TURN OFF THE ELECTRICITY
Verify the wall switch is in the OFF position.
•
Turn off power at the circuit breaker that supplies power to the outlet box you are working on.
•
For screw-in type fuses unscrew the fuse that supplies power to the outlet box you are working on.
•
2. MAKING THE ELECTRICAL CONNECTIONS
If necessary, strip 3/8 in. of insulation from the junction box or fixture (A) wires.
•
Thread the wire through the domed cover plate of the junction box (not provided) or landscape post (not
•
provided).
Make wiring connections into the junction box or post by following the wiring instructions below.
•
ON/OFF WIRING (NON DIMMING) METHOD:
Connect the fixture black wire to the house black wire ((+) line), and fixture white wire to the house white
•
wire ((-) common) by twisting the exposed wires together and using the wire nuts (BB). Ensure there are no
loose wires.
Connect the house ground wire to the green fixture ground wire by twisting the exposed wires together
•
and using the wire nuts (BB)
0-10V DIMMABLE WIRING METHOD:
Connect the fixture black wire to the house black wire ((+) line), and fixture white wire to the house white
•
wire ((-) common) by twisting the exposed wires together and using the wire nuts (BB). Ensure there are no
loose wires.
Connect the house ground wire to the green fixture ground wire by twisting the exposed wires together
•
and using the wire nuts (BB).
Connect the purple wire to the (V+) DIM wire and the pink wire with (V-) DIM wire by twisting the exposed
•
wire together.
Non-Dimming Wiring Diagram
(+) Line
(-) Common
Ground
NOTE: Hold stripped ends near each other and align any frayed strands (do not twist wires). Push the wires into wire nut (BB) and use your fingers to twist
the wire nut clockwise until tight. Check for tightness by pulling wires.
3. SECURING THE FIXTURE AND ADJUSTING ORIENTATION
Secure the fixture to the junction box or landscape post by inserting the threaded swivel knuckle mount (C)
•
into the cover plate or landscape post.
Place the knuckle mount lock nut (D) on the inside of the domed cover plate and tighten the fixture to the
•
plate.
If applicable, plug all unused holes and seal threads with silicone.
•
Loosen the screw (1) on the swivel portion of the knuckle (C) using a Phillips screwdriver. Adjust the fixture
•
to a suitable orientation, and then tighten the screw (1).
LED Flood light Instructions
WARNING: Risk of electric shock. Disconnect power
at fuse or circuit breaker before installing or servicing.
3/8 in.
Black
Lighting
White
Fixture
Green
www.cooperlighting.com
0−10V Dimming Wiring Diagram
Black
(+) Line
White
(-) Common
Purple
(+)DIM V+
Pink
(-)DIM V-
Green
Ground
IL51879322
1
2
A
Lighting
Fixture
3
1
C
D
BB
3