Price Pfister R89 Serie Instrucciones De Montaje página 3

7
7A
7G
7D
7C
7E
7 TRIM FLANGE ATTACHMENT
Position Flange (7A) on Valve (7B) with Drain Hole (7C) at the bottom. Place
Protective Washer (7D) on the short end of the reversible Retainer Sleeve (7E).
Screw Retainer Sleeve (7E) onto threaded section of the Stem and Bonnet (7G).
Tighten Retainer Sleeve (7E) by hand until Flange (7A) is snug to finished wall
surface. If the short end of the Retainer Sleeve (7E) is too short, reverse it to
use the longer end.
8
8B
8A
8 SHOWER ARM INSTALLATION
Insert the end of Shower Arm (8A) through the Shower Flange (8B). Apply PTFE
plumber's tape to back end of Shower Arm (8A) according to manufacturer's
instructions. Screw the end of Shower Arm (8A) into pipe elbow inside the wall.
Slide Shower Flange (8B) tight to the wall.
9
9A
9B
9C
9 SPOUT INSTALLATION
Apply PTFE plumbers tape on both ends of Pipe Niple (9A) (not included). Screw
Pipe Niple (9A) into the elbow inside the wall and tighten with pipe wrench.
7
The Pipe Niple (9A) is to project 3 /
Spout (9B) onto Pipe Niple (9A) and tighten until Spout is properly positioned
and flush to the finished wall.
7B
7C
/ 8 " to 4 "
7
3
" to 4" from the finished wall. Screw Tub
8
ENGLISH
10
10A
10E
10 ARM MOUNT & HOSE INSTALLATION
Screw Arm Mount (10A) into the end of Shower Arm (10B). Connect Hose (10C) into
the Arm Mount Outlet (10D) by turning Metal Hose Fitting (10E).
11
11 HAND SHOWER FUNCTION
To adjust spray, turn switch (11A) to a desired spray pattern.
Center: Pulsating with Full Spray.
Right: Pulsating.
Left: Full Spray.
3
10B
10D
10C
CENTER
RIGHT
LEFT
11A