Worcraft 2120083 Manual De Instrucciones página 28

Tile cutting machine
INTENDED USE
The stone cutting machine can be used for normal cutting work on concrete slabs, cobblestones, marble and granite slabs,
bricks, tiles, etc. as long as the machine is large enough to take them. It is designed for DIY applications and craft businesses. It
should never be used for cutting wood or metal.
TECHNICAL SPECIFICATIONS
Model / Type
Voltage
Input power
Speed
Cutting wheel
Table size
Cut length
0
Max. thickness @90
NOISE/VIBRATION INFORMATION
●
The vibration level given in this information sheet has been measured in accordance with a standardised test given in EN12418
and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is poorly maintained, the vibration emission may differ. This may
significantly increase the exposure level over the total working period.
An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when
it is running but not actually doing the job. This may significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work patterns.
EXPLANATION OF SYMBOLS
Attention!
Read the manual.
Wear eye protection
Wear cut-resistant gloves
Risk of injury from the rotating tool! Keep
hands away
Never use faulty grinding discs
PRODUCT ELEMENTS （Fig.1）
1 Legs
2 Diamond wheel
3 Trough
4 Work table
5 Angle stop
6 Rail fence
SAFETY
GENERAL SAFETY INSTRUCTIONS
Safe operation:
• Keep work area clear. Cluttered areas and benches invite
injuries.
• Consider work area environment.
- Do not expose tools to rain. Do not use tools in damp or wet
locations. Water entering a power tool will increase the risk of
electric shock.
- Keep work area well lit.
- Do not use tools in the presence of flammable liquids or gases.
TC-800A / TSW230A
230V~,50Hz
800W
2950rpm
Ø230 xØ25.4 x2.4mm
1200x394mm
920mm
48mm
0
Max. thickness @45
Insulation class
Protection class
Sound pressure level
Sound power level
Guaranteed sound power level
Vibration
Weight
Pull out mains plug immediately, if the mains cable is
damaged, entangled or severed. Always remove the
mains plug before working on the device.
Wear ear protection.
Wear breathing protection
Wear anti-slip safety shoes
Use only wet diamond cutting discs with a continuous
rim
Electrical appliances must not be disposed of with the
domestic waste.
7 Rail bar
8 Safety hood for the cutting wheel
9 Handle
10 Fixing knob for setting the angle
11 Locking knob for legs
12 Water hose
Power tools create sparks which may ignite the dust or fumes.
• Guard against electric shock. Avoid body contact with
earthed or grounded surfaces (e.g. pipes, radiators, ranges,
refrigerators).
• Keep other persons away. Do not let persons, especially
children, not involved in the work touch the tool or the
extension cord and keep them away from the work area.
• Store idle tools. When not in use, tools should be stored
in a dry lockedup place, out of reach of children.
• Do not force the tool. It will do the job better and safer at
38mm
I
IP54
L :86,8dB(A), Kp :2,5 dB(A)
PA A
Lw :99,8dB(A), K :2,5 dB(A)
A wA
Lw :105dB(A)
A
2
a :10,7 m/s
hv
28kgs