Trust START-LINE ACST-606 Manual De Instrucciones página 4

EN
ACST-606 WIRELESS DOOR/WINDOW SENSOR
1. (Re)place battery
A
Open the battery compartment by sliding the
backplate from the sensor.
B
Optional: Remove the old battery with a
flathead screwdriver .
C Place the (included) 3V CR1632 lithium battery
2. Set the desired switch-off delay
Turn the switch-off delay to the desired position
using a flathead screwdriver. The switch-off
delay can be changed after the sensor is paired
to a Trust Smart Home receiver.
0m: The OFF-signal is sent directly when the
sensor is closed.
1m, 5m, 10m: The OFF-signal is automatically sent
after 1, 5, 10 minutes, regardless whether the
door/window is open or closed.
Place the backplate on the sensor.
3. Pair sensor to receiver
Before pairing the sensor to a receiver make
sure the sensor is closed (place both parts
against each other). To put the ACC-2300
(wireless socket in picture) in learn mode, plug
it into a wall socket. (For other receivers refer
to their manual). While the learn mode is active,
open the sensor (more than 3 cm) to pair it to
the receiver.
4
4. Set sensor operation
The operation of the sensor when it is opened
can be changed by setting the switch to ON or
OFF on the back of the sensor.
4a. ON: When the switch on the sensor is set to
ON, it will send an ON signal when for example
a door is opened to turn a lamp on and an OFF
signal when the door is closed to turn the lamp
off.
4b. OFF: When the switch on the sensor is set to
OFF, it will send an OFF signal when for example
a window is opened to turn the ventilation off
and an ON signal when the window is closed to
turn the ventilation on.
5. Mount sensor
A To mount the sensor using supplied double
sided tape, apply the double sided tape on
the back of both parts of the sensor and place
them onto a window or door frame. The gap
between the parts should be as small as
possible (max. 1 cm).
B
To mount the sensor using the supplied
self-tapping screws, first open the sensor by
sliding off the backplate (of both parts) and
screw (through the indicated screw locations
as shown in the picture) the backplates on a
window or door frame. The gap between the
parts should be as small as possible (max. 1
cm). Place the sensor on the backplates.