YATO YT-85175 Manual De Instrucciones página 13

GB
hot ash, embers, or fi re. Embers scattered by the blow may cause fi re and lead to serious
burns.
When using the machine as a vacuum, it is forbidden to suck in wet or hot debris, e.g., hot
ash. Do not use the machine for blowing or vacuuming snow or water.
Do not direct the air outlet at yourself, other people, or animals.
Before blowing, check the work area and remove any objects that may cause danger. Please
note that ejected particles can bounce off obstacles and hit the operator.
When operating the machine, wear personal protective equipment such as work clothing with
long legs and sleeves as well as protective gloves. Wear eye protection and a face mask.
Moreover, use hearing protection. Wear solid footwear with full uppers and non-slip soles.
Do not obstruct the ventilation openings and make sure they are clear. Obstructed or clogged
ventilation openings may cause the machine to overheat. This can lead to damage to the
machine and cause fi re or electrocution.
If you notice any damage to any part of the machine, you must discontinue using it. In this
case, hand the machine over to an authorised service centre or replace this part by yourself,
provided the user's manual permits this.
Turn off the machine and disconnect the battery before performing any activities related to
replacing parts, cleaning, or adjustment.
Turn off the machine and disconnect the battery before replacing the accessories.
The machine must not be used by children or persons with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, as well as those who fail to read
this manual. Local regulations may restrict the operator's age. Children should not play with
the machine. Children left unattended should not be allowed to perform the cleaning and
maintenance of the machine.
The machine is designed to be operated with two hands. Hold the machine by the handles.
The handles should always point upwards. Make sure that air inlet and outlet are not ob-
structed when holding the product. The air inlet must not be too close to the ground to prevent
dirt from being sucked into the machine.
Keep a proper standing position during work so that you can always maintain balance. When
working on a slope, move across the slope. Never run while working, always walk.
Always use the machine when it is fully assembled. Never use the product without the at-
tached nozzle. Always use a collection bag when using the machine as a vacuum.
Do not touch dangerous moving parts until the machine has been unplugged from the mains
by disconnecting the power cord plug, and the dangerous moving parts have come to a
complete standstill.
Before connecting, make sure that the mains parameters are as indicated on the machine
nameplate.
Always connect the batteries to the machine after making sure that the power switch is in the
off position.
Check the machine's condition each time before you start it, or after dropping it, or when the
blower hits an object. If you notice any damage, such as a cracked housing, you must not
use the machine until the damage has been remedied.
If, during operation, a malfunction or accident occurs, turn off the machine fi rst, disconnect
O R I G I N A L I N S T R U C T I O N S
13