Publicidad
Idiomas disponibles
Idiomas disponibles
You can open or close the side stop by applying a little
pressure to adapt it to the space you need between the
two slats.
5.4. Adjusting slat firmness
The central slats of the Home Silver bed allow adjusting
the firmness of the area.
The more the regulators are separated, the greater the
firmness. Conversely, the closer the regulators are to
each other, the lesser the firmness.
5.5. Assembling the rails (optional)
Assembling the side railings does not require any tools
for their assembly.
The bed base tube where the railing is attached must be
2 cm (0. 78 inches) thick and a maximum of 6 cm (2.3
inches) high. Use the tightening knob located beneath
to attach it to the bed base and make sure to tighten it.
We recommend placing the railing so that it folds down
towards the foot area. Leave a 6 cm (2.3 inches) gap
between the railing and the top corner of the bed base.
Use the release knob to fold down or lock the railing
when needed by pulling outwards.
ESPAÑOL
ITALIANO
6. USE INSTRUCTIONS
6.1. Wire control
1) Rise backrest
2) Recline backrest
3) Rise backrest and legs
simultaneously
4) Recline backrest and
legs simultaneously
5) Rise legs
6) Lower legs
The use of the remote control is
very simple. Simply press the
button and keep pressing until
reaching the desired height.
Remember that the motor is only
activated while the button is
pressed. The moment you stop
pressing, the motor will stop.
6.2. Remote control
1) Rise backrest
2) Recline backrest
3) Rise backrest and
legs simultaneously
4) Recline backrest and
legs simultaneously
5) Rise legs
6) Lower legs
The remote control uses two
AAA batteries to operate,
make sure they have been
inserted and are charged.
The operation is the same as
the wire control. Bear in mind
that it may take a little longer
to activate the motor because since is wireless, there is
a lapse of time between the moment you press the
button and the moment the signal reaches the motor.
6.2.1. Synchronising your remote control
To synchronise a remote control with a motor, you must
first ensure that the remote control is not linked to
another motor. To do this, you must desynchronise the
control of any motor to which it is linked.
-
First step: desynchronisation
Press and hold buttons 1 and 4 on the remote control
for 3 seconds. The light on the remote control buttons
will flash: this means that it has been successfully
desynchronised.
-
Second step: synchronisation
Press the coding button on the motor and you will hear
a beep (this is the only button on the motor). Then press
and hold buttons 2 and 3 on your remote control until
you hear another beep: the remote control and motor
are now correctly synchronised.
21
FRANÇAIS
ENGLISH
Publicidad
