Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL DATA
Type
Rated power input
Voltage Battery
Charging current
USB input
Luminous flux (Flood)
High
Low
Luminous flux (Spot)
High
Low
Luminous flux (Hybrid mode)
Lighting time (Flood)
High
Low
Lighting time (Spot)
High
Low
Lighting time (Hybrid mode)
Colour rendering index (CRI)
Colour temperature
Protection class
Weight
Charging time
Battery Type
Recommended ambient operating temperature
Recommended ambient charging temperature
Recommended USB power supply
WARNING!
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
SAFETY INSTRUCTIONS BATTERY-LAMP
WARNING: Use only the recommended USB cable and charger.
Warning: Do not direct the light beam at persons or animals and
do not stare into the light beam yourself (not even from a distance).
Staring into the light beam may result in serious injury or vision loss.
The light source of this luminaire is not replaceable; when the light
source reaches its end of life the whole luminaire shall be replaced.
SAFETY INSTRUCTIONS BATTERY
Battery acid may leak from damaged batteries under extreme load
or extreme temperatures. In case of contact with battery acid wash
it off immediately with soap and water. In case of eye contact rinse
thoroughly for at least 10 minutes and immediately seek medical
attention.
Warning! To reduce the risk of fire, personal injury, and product
damage due to a short circuit, never immerse your tool, battery pack
or charger in fluid or allow a fluid to flow inside them. Corrosive or
conductive fluids, such as seawater, certain industrial chemicals,
and bleach or bleach containing products, etc., can cause a short
circuit.
SPECIFIED CONDITIONS OF USE
The headlight is intended to be used light independent use away
from mains supply. The headlight is especially designed for head
mounting.
Do not use this product in any other way as stated for normal use.
14
IR-HL450
Head Light
5 W
3,7 V
0,1 A - 0,5 A
5V DC, 0,1 A - 2,1 A
250 lm
50 lm
250 lm
100 lm
450 lm
4 h
14 h
4 h
8 h
2,5 h
70
4000 K
IP 54
0,12 kg
< 4 h
ICR10440
-20°C... +40°C
0°C... +45°C
CUSB
CHARGING
Plug your USB cable into a power source such as an AC wall
adaptor, computer or car port.
The indicator light will display the charging status:
Red flashing: charging, 0-49% charged
Yellow flashing: charging 50-99% charged
Green solid: 100% charged
Red/Green flashing: damaged battery, charging error or charging
timeout
If the light indicator flashes red and green, check that the USB-
Cable is fully seated into the socket. Remove the USB-Cable and
reinsert. If the light continues to flash red and green, the battery may
be extremely hot or cold. Allow the battery to cool down or warm up
and then reinsert the USB-cable. If the problem persists, contact a
MILWAUKEE service facility.
FUEL GAUGE
The fuel gauge will display the battery life:
Red flashing: < 3% remaining
Red solid: 3-9% remaining
Yellow solid: 11-49% remaining
Green solid: 50-100% remaining
ENGLISH
NOTES FOR LI-ION BATTERIES
Use of Li-Ion batteries
Batteries which have not been used for some time should be
recharged before use.
Temperatures in excess of 50°C (122°F) reduce the performance
of the battery. Avoid extended exposure to heat or sunshine (risk of
overheating).
The contacts of chargers and batteries must be kept clean.
For an optimum life-time, the batteries have to be fully charged, after
used.
To obtain the longest possible battery life remove the battery pack
from the charger once it is fully charged.
For battery storage longer than 30 days:
Store the battery where the temperature is below 27°C and away
from moisture
Store the battery in a 30% - 50% charged condition
Every six months of storage, charge the battery as normal.
Transport of Li-Ion batteries
Lithium-ion batteries are subject to the Dangerous Goods Legislation
requirements.
Transportation of those batteries has to be done in accordance with
local, national and international provisions and regulations.
• The user can transport the batteries by road without further
requirements.
• Commercial transport of Lithium-Ion batteries by third parties is
subject to Dangerous Goods regulations. Transport preparation
and transport are exclusively to be carried out by appropriately
trained persons and the process has to be accompanied by
corresponding experts.
When transporting batteries:
• Ensure that battery contact terminals are protected and insulated
to prevent short circuit.
• Ensure that battery pack is secured against movement within
packaging.
• Do not transport batteries that are cracked or leak.
Check with forwarding company for further advice
MAINTENANCE
Use only Milwaukee accessories and Milwaukee spare parts. Should
components need to be replaced which have not been described,
please contact one of our Milwaukee service agents (see our list of
guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the machine type printed as well as the six-digit No. on
the label and order the drawing at your local service agents or
directly at: Techtronic Industries GmbH, Max-Eyth-Straße 10,
71364 Winnenden, Germany.
Please visit our website www.milwaukeetool.eu for further
information on warranty conditions and registration.
SYMBOLS
Please read the instructions carefully before starting
the machine.
CAUTION! WARNING! DANGER!
Do not stare at the operating light source.)
USB Port
Class III electrical protection.
This tool is only suitable for indoor use. Never expose
tool to rain.
Do not dispose of waste batteries, waste electrical and
electronic equipment as unsorted municipal waste.
Waste batteries and waste electrical and electronic
equipment must be collected separately.
Waste batteries, waste accumulators and light sources
have to be removed from equipment.
Check with your local authority or retailer for recycling
advice and collection point.
According to local regulations retailers may have an
obligation to take back waste batteries and Waste
electrical and electronic equipment free of charge.
Your contribution to re-use and recycling of waste
batteries and waste electrical and electronic equipment
helps to reduce the demand of raw materials.
Waste batteries, in particular containing lithium and
waste Electrical and electronic equipment contain
valuable, recyclable materials, which can adversely
impact the environment and the human health, if not
disposed of in an environmentally compatible manner.
Delete personal data from waste equipment, if any.
European Conformity Mark
UK Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark
ENGLISH
15
Publicidad
