Publicidad
Regulatory Compliance and Safety Information Cisco Firepower 1010 Series
Statement 1090 Installation by Skilled Person
Warning
Only a skilled person should be allowed to install, replace, or service this equipment. See statement
1089 for the definition of a skilled person.
Statement 1091 Installation by an Instructed Person
Warning
Only an instructed person or skilled person should be allowed to install, replace, or service this
equipment. See statement 1089 for the definition of an instructed or skilled person.
Statement 1252 Equipment Grounding
Warning
This equipment must be grounded. To reduce the risk of electric shock, the power cord, plug, or
combination must be connected to a properly grounded electrode, outlet, or terminal.
Statement 2017 Class A Notice for FCC
Note
Modifying the equipment without Cisco's authorization may result in the equipment no longer complying
with FCC requirements for Class A digital devices. In that event, your right to use the equipment may be
limited by FCC regulations, and you may be required to correct any interference to radio or television
communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case users are required to correct the interference at their own
expense.
Regulatory Compliance and Safety Information - Cisco Firepower 1010 Series
9
Publicidad
