Elinchrom ELC PRO HD 500 Manual De Funcionamiento página 18

ERROR MANAGEMENT
ERROR
DESCRIPTION
NUMBER
1 Capacitor over voltage
2
3 Discharge error
4 Charge timeout error
5
Charge hold error
6
10 Supply input voltage too high
11 Supply input voltage too low
Supply under voltage detected until
12
13 Over current detection
Temperatur sensor "Heat Sink" not
15
Temperatur sensor "Front"not
16
Temperatur sensor "Charge" not
17
20 Power Board not connected / found
24
Capacitor voltage symmetry error
28 Flash tube after glow
29 Auto Ignition on Charge
30
Auto Ignition on Ready
Over heat
Fan error
charge
connected
connected
connected
User Manual
SOLUTION
Switch the unit off, wait 2 minutes and switch
the unit on again. If the error shows up again
the unit requires a check up at an authorized
Elinchrom service centre.
Wait until the unit has cooled down.
The unit will switch back to the normal
operation as soon as the temperature
decreases to a normal working level.
Switch the unit off, wait 2 minutes and switch
the unit on again. If the error shows up again
the unit requires a check up at an authorized
Elinchrom service centre.
The unit has detected a mains supply fault.
Please check the mains/battery inverter
supply.
It could be not working correctly.
Switch the unit off, wait 2 minutes and switch
the unit on again. If the error shows up again
the unit requires a check up at an authorized
Elinchrom service centre.
Switch the unit off, wait 10 minutes and
switch the unit on again. If the error shows
up again the unit requires a check up at an
authorized Elinchrom service centre.
Switch the unit off, wait 2 minutes and switch
the unit on again. If the error shows up again
please change flashtube. If it still happens
the unit requires a check up at an authorized
Elinchrom service centre.
EN
17