Publicidad
Idiomas disponibles
Idiomas disponibles
Display and keyboard
There are two main function modes:
RUN and PRO. PRO mode is when
configuration
menu
is
programm the indicator, whereas RUN
is the normal mode in which display
shows
the
reading
configuration and input signal value.
The table below summarizes display
parts
description
and
keyboard function.
1
4 red digit Display
2
Minus sign LED (only in JR-D)
3
Keyboard
4
Setpoint 1 LED
5
UP key
6
SHIFT key
7
DATA/ENTER key
8
Setpoint 2 LED
9
Free space for units label
Installing and connecting recommendations
This instrument coforms with the following community directives: EMC 2004/108/CE and LVD 2006/95/CE.
Refer to the instructions in this manual to preserve safety protections.
WARNING: If this instrument is not installed and used in accordance with this instructions,
the protection provided by it against hazards may be impaired.
To meet the requirements of EN 61010-1 standard, where the unit is permanently connected to main
supply, its is obligatory to install a circuit breaking device easy reachable to the operator and clearly
marked as the disconnecting device.
To guarantee electromagnetic compatibility, the following guidelines should be kept in mind:
•
Power supply wires should be separatedly routed from signal wires and never runned in the same
conduit.
•
Use shielded cable for signal wiring.
•
Cables section should be 0.25 mm².
Before connecting signal wires, signal type and input range should be verified to be within the right
limits. Do not connect simultaneously more than one input signal to the meter.
SERIE KOSMOS
entered
to
2
according
to
LEDs
and
3
RUN MODE
Shows value according configuration.
(Not used)
It iluminates when Setpoint 1 turns active.
Main Counter RESET (when pressing more than 3s).
Displays maximum and minimum stored values
(tachometer mode only).
After 3s of pressing, sets maximum and/or minimum
memorized
value
to
(tachometer mode only).
Shows sequentially totalizer value in two parts, 'H'
and 'L' of 3 digits each (counter mode only).
Totalizer RESET (when pressing more than 3s)
Changes to PRO mode.
It iluminates when Setpoint 2 turns active.
www.ditel.es
UP
1
4
5
Shows steps and data during configuration.
(Not used)
—
It iluminates when Setpoint 1 turns active.
Shows Setpoints value.
Increases value of active digit.
current
display
value
Shifts active digit to the next right digit.
Shows sequentially menu options.
Validates selected data and parameters.
Moves one step forward in configuration menu.
Changes to RUN mode.
It iluminates when Setpoint 2 turns active.
—
JR-D / JR20-D
DATA
SHIFT
2
ENTER
6
7
8
PRO MODE
—
—
1
9
57
Publicidad
