Publicidad
Idiomas disponibles
Idiomas disponibles
6.3
Clean stainless steel surfaces
. After using pungent cleaning agents, wash off the cleaned part thoroughly using water and rub
dry.
. Clean stainless steel surfaces with grease-dissolving cleaner or a special stainless steel cleaner.
. Dry cleaned parts and surfaces with a soft cloth.
7.
Faults and fault rectification
Check any faults in the appliance against the following table:
Fault
The green indi
cator light does
not illuminate
when switched
on.
The appliance is
switched on but
does not heat
up.
If you cannot remedy the fault,
‒ switch off the appliance and disconnect from the mains,
‒ do not open the housing,
‒ contact the authorised Customer Service agent.
Possible cause
Main switch before appliance
not turned on.
There is no power supply at
all.
Mains fuse on site has
tripped.
The appliance is overheated.
Action
Turn on main switch.
Inform the power supply company.
Possible faults on the appliance must
be checked by an authorised Customer
Service agent.
Reset the circuit breaker.
Allow the appliance to cool.
If the fault continues to occur, contact
the authorised Customer Service.
en
23 / 80
Publicidad
