Pur Line NTW-01 PLUS Manual De Instrucciones página 9

EN
INSTALLATION
PARTS:
3
1
1. Screw anchors for wall mounting
4
2
2. Hanger
3. Screws
4. Hanger screw covers
5. Indicator lamp / Power switch
6. Power plug
7. Towel rail
7
The towel warmer must not be
installed in close vicinity to water.
A distance of at least 0.6 meters
between towel warmer and screened
off shower or wash-basin is required.
If you are not sure, it's recommended
to ask a qualified electrician for help.
5
6
• WARNING:
Fixed heaters likely to be used in a
bathroom are to be installed so that
switches and other controls cannot
be touched by a person in the bath or
shower.
To hang the heater on the wall:
1. Mark screw holes on the wall with a pencil.
2. Drill holes in the wall.
3. Insert screw anchors into the holes.
4. Put hangers on the wall and install it with the screws.
Always be sure that the heater is correctly fixed and
stable after performing the installation !
To place your heater with stand:
Screw the legs to the towel rail to place it on the floor.
7