Publicidad
Idiomas disponibles
Idiomas disponibles
5 - High-pressure cable
6 - Water outlet
7 - Spray gun
8 - Power supply (not included)
CAUTION! This appliance must only be connected to a cold water supply.
CAUTION! The engine of this pressure washer will only run when the trigger is
pressed.
1) Connect the outlet hose to the washer and connect the spray gun to the
outlet hose.
2) Connect the nozzle and the nozzle extension.
3) Check that the filter is not clogged.
4) Connect the water inlet hose.
5) Check that the hose is not tangled.
6) Turn on the water and check for leaks.
7) Squeeze the trigger to allow air to escape through the pump and hoses, and
lock the trigger.
8) Plug in the unit and set the ON/OFF switch to the ON position.
9) Unlock the trigger and use your pressure washer.
Switching off
1) Turn off the engine (turn the ON/OFF switch to the OFF position)
2) Disconnect the unit from the power supply.
3) Turn off the water supply.
4) Trigger the gun to release pressure from inside the unit.
5) Disconnect the garden hose from the pressure washer.
6) Wipe all surfaces of the unit with a damp, clean cloth.
7) Engage the gun safety lock.
NOTE: Always turn off the machine's motor before shutting off the water supply. If
operated without water, the engine may be seriously damaged.
NOTE: Never disconnect the high-pressure outlet hose from the machine while the
system is still pressurized. To release pressure from inside the unit, turn off the
engine, shut off the water supply and squeeze the trigger 2-3 times.
Spray nozzles
The pressure washer is equipped with four spray nozzles. Each nozzle is color-coded
and provides a proper spray shape and pressure for the specific task. The size of the
nozzle affects the width and pressure of the jet.
0° nozzle - red: This nozzle provides a point-like stream of water under pressure and is
extremely efficient. It covers only a small area while cleaning. This nozzle should only
Publicidad
