Publicidad
Idiomas disponibles
Idiomas disponibles
d)
After each cleaning, all the parts should be dried well before the unit is used
again.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any
damages.
i)
Use a soft, damp cloth for cleaning.
j)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as they may damage the surface of the appliance material.
k)
Do not clean the device with acidic substances, medical products, thinners,
fuel, oil or other chemicals as this may damage the device.
l)
If the device is not used for a long time, disconnect it from the power supply,
drain the accumulated water, and thoroughly wipe the ice container with a
clean cloth.
DISPOSAL OF WASTE APPLIANCES
At the end of its useful life, this product should not be disposed of with normal
household waste but should be taken to a collection point for the recycling of
electrical and electronic equipment. This is indicated by the symbol on the
product, operating instructions or packaging. The materials used in this appliance
are recyclable according to their marking. By reuse, recycling or applying other
forms of use of waste machines, you make a significant contribution to the
protection of our environment.
Your local administration will provide you with information about the appropriate
disposal point for used appliances.
TROUBLESHOOTING
Problem
The unit does
not work.
The compressor
runs but no ice
Possible cause
a)
Voltage is too low.
b)
The ambient
temperature of the
environment in which
the device is located is
below 10
C.
o
a)
Refrigerant leakage -
leakage in the system.
Recommendation
a)
Turn off the device and
start it only when the
voltage has stabilized.
b)
Wait until the ambient
temperature rises or
install the device in a
place with a higher
ambient temperature.
a)
Fill up the system with
the refrigerant and
check for leaks.
Publicidad
