EN
Cleaning (cont.)
Unplug the humidifier.
1.
Remove and rinse the water tank cover. [Figure 3.1]
2.
Remove the water tank from the base and pour
3.
out any water from the tank and base chamber.
[Figure 3.2]
Note:
When pouring out water, hold
down the float to ensure that it does
not fall out of the base chamber.
Figure 3.1
Remove the water filter assembly from the
4.
tank by rotating it anticlockwise and lifting it
out. [Figure 3.3]
Rinse the tank, water filter assembly, and
5.
base chamber with room temperature water.
[Figure 3.4]
Figure 3.3
Descaling Your Humidifier
Remove the water filter from the tank by
1.
rotating it anticlockwise and lifting it out.
[Figure 3.5]
Fill the tank with 710 mL cups of distilled white
2.
vinegar. [Figure 3.6]
Figure 3.5
10
Figure 3.2
Figure 3.4
Figure 3.6
Replace the tank cover and swish the vinegar
3.
around the tank. [Figure 3.7]
Place the tank on the base and soak for
4.
15–20 minutes. Vinegar will drain into the base
chamber and loosen scale (mineral buildup) in
the tank and in the base chamber (including the
transducer and float). [Figure 3.8]
Figure 3.7
Remove the tank, remove the tank cover, and
5.
pour out any vinegar. [Figure 3.9]
Flip the tank over and remove the noise
6.
silencer. To remove the noise silencer, press
the release tabs and gently pull away from the
humidifier. [Figure 3.10]
Figure 3.9
Remove the float from the base chamber by
7.
pulling up one end of the float [Figure 3.11] and
pulling the shaft out from the float brackets. One
side of the float brackets is open (U-shaped) to
allow the shaft to be removed. [Figure 3.12]
Figure 3.11
Place the float, water filter assembly, and noise
8.
silencer in a small container. Fill with enough
vinegar to cover them. Soak for 15–20 minutes.
[Figure 3.13]
Figure 3.13
Figure 3.8
Figure 3.10
Figure 3.12