LaserTrack LT445 Manual De Instrucciones página 4

Important information
Accessories (optional)
A special waterproof LED transponder for motorcycles is available. For motorcycles order the Target
LT400-M. The control elements of this set are completely waterproof and weatherproof. This system also
has a special optical signalling system that is always visible to the motorcyclist.
Important information
Nearly all laser systems using infrared light emit their information on a frequency of 904 nanometre
(this is the wave length which emits infrared laser light). This is also true for the LaserTrack. This wave
length has become the worldwide standard. Even the police laser guns emit speed measurements on
this wave length. Target LaserTrack is the only system that has intelligent electronic technology that
can recognize the signals of laser guns and other laser systems that use the same wave length; e.g.
hunting or surveyor range fi nders, police laser systems or vehicles fi tted with laser based adaptive
cruise control systems. After recognizing a an infrared signal that is not its own, Target LaserTrack
temporarily shuts itself off to prevent failures and, for example, to allow a laser speed measurement to
take place. You are informed of this through a visual and audio signal.
Installation
Follow the instructions below to the letter to ensure that the system performs optimally.
Mounting and connecting the LT400 car transponder
1. Mount the transponder preferably in the middle at the front of the vehicle (preferably very near
to the number plate). The transponder may also be mounted behind the grill. The free passage
opening should be larger when the distance from the transponder to the opening is greater.
Refer to the calculation table on page 8.
2. Mount the transponder using the tee bolt and mounting bracket included in the package. Refer to
Transponder Alignment on page 7.
3. Ensure the transponder is aligned correctly. Refer to Transponder Alignment on page 7.
4. Lead the transponder cable through the engine compartment. Use the cable guides already present
when possible. Do not pull the cable too tightly and do not kink the cable. Lead the cable through
the existing grommet to the interior. Connect as indicated in the diagram on page 76.
6