LaserTrack LT445 Manual De Instrucciones página 7

Testing the operation
The correct operation of the system can be tested after the Target LT400 has been installed according
to the instructions:
1. Switch the system on by starting the vehicle (if the switch has been added then it must be set to ON).
Result: The system emits a short audio signal and the LED is switched on for 2 seconds. The LT400
will be in test mode for 10 seconds only.
2. Test the operation of the laser receiver using an infrared remote control device (for audio or video
equipment). Hold the remote control device in front of the transponder lens (at a distance of
approximately 10 cm) and at the same time press a button of the remote control device.
Result: The system emits a warning signal and the LED is switched on.
3. Stop pressing the button of the remote control device when you are satisfi ed that the system is
functioning correctly.
Result: After the last received signal the LED will be switched on for 10 seconds. After the 10 seconds
have elapsed the system will emit two short audio signals. The LT400 is now in the stand-by mode.
Important information for all users
■ Check frequently whether the lens of the transponder is dirty. The eff ect of dust and grit on the
functioning of the system is very limited. Objects that cover the lens completely, such as leaves or
insects, should be removed at once.
■ Check frequently whether the housing and the lens of the transponder show signs of damage.
Contact your dealer if the lens is damaged.
■ A dealer should check the tuning of the transponder periodically (for example, when the vehicle is
serviced).
Manual Target Laser track
9