MESTIC MG-135 Instrucciones De Uso página 7

3. INSTALLATION
1.Before first use, wipe the plates with a clean cloth.
2.Install the device on a horizontal and stable work surface.
3.Position the grease drip tray into the slot provided for this purpose.
4.Make sure you have one outlet nearby so that the cable is neither stretched nor in a zone of passage.
5.Plug in the supplied thermostat.
6.Plug the power cord into the socket.
7.Turn the thermostat clockwise to the highest setting. The indicator light will now turn on.
8.Preheat for at least 5 minutes and wait until the temperature indicator light turns off, before placing any food onto
the grill.
9.When the device is turned on for the first time, it will produce a light odour. This is normal and temporary.
10.Using a heat resistant layer between the device and a table is advised.
11.Place the device in a well-ventilated space
4. USE
1.Grease the plates with butter, margarine or cooking fat.
2.Select the desired temperature with the thermostat knob.
3.Never use sharp objects on the grill, this will damage the non-stick coating.
4.Once you have finished cooking, disconnect the plug from the wall socket and let the appliance open for it to cool
down.
5. MAINTENANCE AND CLEANING
In any event, unplug and let the appliance cool down before cleaning.
1.Reminder: do not immerse the appliance in water or any other liquid. Do not place the appliance in the dishwasher..
2.Do not use tools or abrasive solutions that would damage the coating of trays. You can use a wooden kitchen utensil
or paper towel to remove most of the dirt..
3.After each use, empty the fat collecting tray and clean it with warm water and soap.
4.Clean the trays with a slightly damp sponge, or equivalent, and washing up liquid..
5.Wipe the outside of the appliance with a damp cloth only.
6.Allow the device to dry after cleaning. Do not connect it if it is not dry.
Recycling
This product bears the selective sorting symbol for waste electrical and electronic equipment This means
that this product must be handled pursuant to European Directive 2012/19/EU in order to be recycled or
dismantled to minimize its impact on the environment. For further information, please contact your local
or regional authorities. Electronic products not included in the selective sorting process are potentially
dangerous for the environment and human heath due to the presence of hazardous substances.
Declaration of conformity
Hereby Gimeg Nederland B.V. declares that the device MG-135, applies all basic requirements and other relevant
regulations listed in the European directive for electromagnetic compatibility (2014/30/EU) and low voltage directive
(2014/35/EU). If you require a full declaration of conformity, you can contact the adress listed on the backside of this
manual