Publicidad
Idiomas disponibles
Idiomas disponibles
5. Wipe away any food or liquid on the vacuum channel with
a paper towel.
6. Dry the appliance thoroughly before using it again.
7. The weighing sensor of scale is a precise part. Please
gently wipe the platform when cleaning. Do not press it too
hard. You can remove the platform for cleaning.
X. Troubleshooting
Nothing happens when the power cord is plugged into appliance
Make sure the power cord is not damaged.
Make sure both ends of the power cord are correctly plugged into the electrical outlet
and appliance.
Appliance is plugged in, but air is not vacuumed from the bag
Ensure the lid is closed and electromagnet latch is locked. Ensure the open end of the
bag is correctly placed into the vacuum channel.
Allow the appliance to cool for 30 seconds between uses.
Air was removed from the bag, but now air has reentered
Check if there is a hole on the bag. It may be punctured by sharp foods. Use a new
bag if this happens.
Check the seal. A wrinkle along the seal may cause air to reenter the bag. If there is a
wrinkle along the seal, simply cut the sealed edge and reseal.
If there is moisture or liquid from foods present within the seal,cut open the bag and
wipe away foods on the open end of the bag. Choose MOIST FOOD setting and
reseal.
If the food has been stored for a long time and the bag is full of gases, the food may
spoil. We recommend discarding the food.
XI. Note:
To prevent the appliance from overheating, allow it to cool for 30 seconds between
uses. Keep the lid in the upright position before vacuum sealing. If the bag melts,
the sealing strip may have been too hot during the sealing process. Allow the
appliance to cool for 30 seconds between uses. For best results, do not reuse the
bags after storing raw meats, fish or greasy foods before. Do not reuse bags after
simmering or microwaving.
Publicidad
