AYR 759 Manual De Usuario página 17

2. Installation Instructions:
1. - Remove the traditional optical door viewer on the door (If no existing
hole on the door, please use a driller to drill a round hole with a diameter
of 14mm) , select the screw that fits the door thickness and screw into
the camera hole.
EN
2.- Peel off 3M sticker on the back side of the camera and carefully cross
the FPC cable through the door hole from the outside. Stick the camera
on the door with the call button at the bottom.
EXTERIOR INTERIOR
3.- Peel off 3M sticker on the back side of the holding plate, cross the
FPC cable through the middle hole of the holding plate and pass the
screw through the upper and lower hole of the holding plate. Slide
the holding plate to the left, stick the holding plate on the door and
tighten the screw to fix the holding plate.
EXTERIOR INTERIOR
4.- Connect the FPC cable to the display unit, bend the excess length of
cable neatly and place it in the groove on the back side of the display
unit. Finally buckle the display unit on the holding plate from top to
bottom.
17