Publicidad
Start Up
4. Finally, connect to the AC outlet (E) after a good
connection has been established.
E
5. Disconnect the mains
plug before disconnecting
the battery, and then
remove the battery clamps
or washers.
Safety device
1. The charger will automatically go into sleep mode when
charging is finished to prevent overcharging.
2. The charger is protected against short-circuit on the AC
input.
3. Over-temperature protection:
The charger will shut down when the charger is used for a
long time at high temperature and/or when the inside
temperature of the charger exceeds the preset temperature.
When the temperature becomes normal, the charger will
automatically return to normal charging mode.
4. The charger has over-voltage protection.
5. Fire protection.
No clamp output when disconnected with battery to avoid
sparks.
6. Low voltage activation.
The charger will enter charging mode automatically when
the voltage at the end of the clamp is higher than 2 V d.c.,
the charger will not charge if the voltage is lower than 2 V
d.c.
7.
WARNING
Use the correct charging voltage
according to the rated voltage of the battery, or the battery
will be damaged.
8.
Do not charge the battery when the
WARNING
engine is running.
7
Publicidad
