VITO PRO POWER VIPL6 Manual De Instrucciones página 30

The cutting depth can be adjusted between 0 - 2 mm.
1. Turn the cutting depth adjustment knob (4) to the
desired depth.
At the beginning of work, always select a small
cutting depth and test on the workpiece. Repeat the
procedure until the desired depth is reached.
The parallel guide is used to ensure that thinning is carried
out parallel to the end (edge) of the workpiece. The cutting
width can be set between 0 - 82 mm.
1. Loosen the parallel guide fixing bolt (3);
2. Adjust the guide to the required cutting width;
3. Tighten the bolt.
1. Touch the front part of the base plate to the workpiece;
2. Press the lock-on button (5) and the "ON/OFF" switch (8)
simultaneously;
If you do not press the lock-on button, the "ON/OFF"
switch remains locked.
3. Let the blade reach maximum speed;
4. Move the planer towards the workpiece continuously and
smoothly, always with the parallel guide (1) against the
edge of the workpiece;
5. To switch off the planer lift it off from the workpiece
surface and release the "ON/OFF" switch.
Ensure that the blades do not contact the workpiece
before starting the planer.
The front part of the base plate has a V-groove that allows
for chamfering edges.
1. Select the desired cutting depth on the adjustment knob
(4);
2. Position the V-groove on the edge that you want to
chamfer;
3. Press the lock-on button (5) and the "ON/OFF" switch (8)
simultaneously;
If you do not press the lock-on button, the "ON/OFF" switch
remains locked.
4. Let the blade reach maximum speed;
5. Push the planer towards the workpiece continuously;
6. To switch off the planer lift it off from the workpiece
surface and release the "ON/OFF" switch.
Before chamfering the edge of the workpiece, carry
out a depth test on the edge of a piece of wood.