FUXTEC FX-RM4180 Manual De Instrucciones página 34

Original User Manual FUXTEC Petrol Lawnmower FX-RM4180
Maintenance work
Changing the cutting knife
Attention!
We recommend contacting FUXTEC customer service and the FUXTEC workshop for this task.
Attention!
Drain the oil from the oil tank before removing the blade.
If you want to replace the cutting blade, remove the screw (see the following figure). Carry out the
installation according to the illustration. Tighten the screw. The tightening torque is 40 Nm. When
replacing the cutting blade, the fixing screw should also be replaced.
Oil change
Attention!
We recommend that you contact professionals for this task.
The engine oil is drained via the oil filler neck. Place a suitable container to collect the
used oil under the engine before opening the nozzle. Then tip the device to the side so that all the oil
can drain out of the tank.
After draining the oil, replace the plug in the opening, ensure that the pin is firmly in place, and wipe
off any spilt oil.
34