Bosch GHG18V-50 Instrucciones De Funcionamiento Y Seguridad página 11

may result in electric shock, fire and/or serious injury.
tect yourself and others from hot paint trimmings and gas or dust.
Be sure the fan is moving the air from inside to outside.
To reduce the risk of injury, do not remove or attach accessory tips until
tool has cooled to room temperature.
Removing Paint & Adhesives
paint. The peelings, residue and vapors of
paint may contain lead, which is poisonous.
Any pre-1977 paint may contain lead and
paint applied to homes prior to 1950 is likely
to contain lead. Once deposited on surfaces,
hand to mouth contact can result in the in-
gestion of lead. Exposure to even low levels
of lead can cause irreversible brain and ner-
vous system damage; young and unborn chil-
dren are particularly vulnerable.
1. Briefly soften the paint or adhesive with
hot air. Move the heat gun slowly and con-
stantly from side to side to evenly distrib-
ute heat. Many adhesives can be softened
by using heat. Long heat exposure burns
Soft Soldering
1. Attach the reduction nozzle (Fig. 3, 10).
2. If you are using solder without flux, apply
soldering grease or paste to the solder
joint.
3. Heat the solder joint.
4. Apply the solder. The solder must be
melted by the temperature of the work-
piece.
5. If necessary, remove the flux after the sol-
der joint has cooled down to room tem-
perature.
1600A02E16 GHG18V-50 20211221.indd 11
Applications
Read all safety warnings, instructions, illustrations and specifications
provided with this heat gun. Failure to follow all instructions listed below
To reduce the risk of fire, property damage, or personal injury, place a
protective shield between the heating area and adjacent surfaces. Pro-
Move the work piece outdoors. If this is not possible, keep the work area
well ventilated. Open the windows and put an exhaust fan in one of them.
Extreme care should be
taken when stripping
the paint or adhesive and makes removal
more difficult.
2. Remove paint or adhesive with a clean
spatula.
10
-11-
FIG. 2
FIG. 3
12/21/21 7:52 AM