Stanley FATMAX FMHT82565-0 Manual De Instrucciones página 11

Diode measurement
1
Insert the black probe into the "COM" jack and the red one into
the "VΩmA" jack, then the red probe will be of positive polarity.
2
Turn the function/range switch to "
probe to the positive pole of the diode being measured and the
black one to the negative pole, read the approximate forward
voltage drop of the diode on the display.
Circuit On-Off measurement
1
Insert the black probe into the "COM" jack and the red one into
the "VΩmA" jack.
2
Turn the function/range switch to the "
the probes in parallel with two points of the circuit being
measured. If the resistance between the two points is less
than 30Ω, the built-in buzzer will beep to indicate the continuity
between the two points.
Battery voltage measurementt
1
Insert the red probe into the "VΩmA" jack and the black one into
the "COM" jack.
2
Turn the function/range switch to the range of "
the probe to the battery or load to be measured.
The polarity touched by the red probe will be on the display.
Replace test leads
Replace test leads if leads become damaged or worn.
Use meet EN 61010-031 standard, rated CAT III 600V, MAX 10A or better test
leads.
", and connect the red
" position and connect
WARNING
EN
" and connect
11