Stanley FATMAX FMHT82565-0 Manual De Instrucciones página 5

• Do not exceed the input limits specified for each range.
• When the instrument is measuring, do not touch the input
terminal not in use.
• When a measurement range is uncertain, turn the function/
range switch to the maximum range position.
• Before turning the function/range switch, make sure the probe
is open with the circuit being measured.
• Before on-line resistance measurement, turn off all power and
discharge all capacitors.
• Be careful when taking measurement of voltage higher than
60V DC/30V AC. Remember to keep your fingers behind the
hand shield of the probe.
• When measuring a TV set or switch power supply, watch for
pulse in the circuit that may damage the multimeter.
• Measure known voltage with the meter to verify that the meter
is working properly. If the meter is working abnormally, stop
using it immediately A protective device may be damaged.
If there is any doubt, please have the meter inspected by a
qualified technician.
• Before taking the measurement of voltage with the probe,
make sure there is no electronic element connected to the test
socket of the transistor.
Maintenance
• Before removing the rear cover, disconnect the probe from the
circuit to be measured.
• To protect the internal circuit, replace the fuse with one of the
same specification:
F1:FF 10AH 600V, 10KA; F2:FF 400mAH 600V, 10KA
• Don't use the instrument until the rear cover is placed back
and the screws are tightened.
EN
EN
5