Bona OptiSpread UX Manual De Funcionamiento página 11

• Ensure that the sachets (foil bags) and cartridges are the right size for this power tool.
Ensure that the sachets (foil bags) and cartridges fit well in the barrel for sachets (foil
bags)/cartridges and that this barrel is securely attached to the power tool. Only then
should you begin to dispense material.
• Never try to dispense material from an incorrectly aligned or blocked cartridge.
• To prevent hazards caused by parts flying around, ensure that the power tool is never
operated with loose front barrel caps. If the dispensing nozzle becomes blocked during
use, you must replace it.
• Never point the power tool at yourself or anyone else during use.
4.9. Product Description and Specifications
Read all the safety and general instructions. Failure to observe the safety and
general instructions may result in electric shock, fire and/or serious injury. Please
observe the illustrations at the beginning of this operating manual.
4.10. Intended use
The Bona OptiSpread UX is a parquet adhesive applicator, specially developed for applying
the high-viscosity adhesives Bona R848T or Bona Quantum T to dry, dust- and grease-free
substrates. In principle, other adhesives manufactured by Bona GmbH Germany can also
be squeezed out in the 9 kg foil bag. The device should enable you to do your work faster,
easier and, above all, more ergonomically.
By pressing the on/off switch, the adhesive is pressed out of the nozzle and can thus be
applied quickly and evenly to the subfloor.
The drive used presses the adhesive out of the adhesive nozzle easily and evenly. The
amount of adhesive applied can be individually adjusted for each work process by means of
the different notches, the application speed and/or the feed speed.
EN
Operating manual
11