Descargar Imprimir esta página

Bona OptiSpread UX Manual De Funcionamiento página 13

Ocultar thumbs Ver también para OptiSpread UX:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Quantity
Part
1
Bona OptiSpread UX
1
Battery charger BOSCH GAL 18V-40
2
18.8 V Li battery blocks BOSCH Pro Core 18V 4.0 Ah
3
Nozzles 1250 F [B12] (optionally available 850F or 1500 F/G)
1
Nozzle head
1
Support stand
1
Hool spanner
1
Screwdriver PZ 1/80
1
Screw set for nozzle assembly
1
Transport bag
To open the tubular bags, we recommend using a pair of pliers, which are not included in
the scope of delivery.
6.2. Operation
6.2.1. Charging the battery
Use only the chargers listed in the technical data. Only these chargers are matched to the
lithium-ion battery of your power tool.
Note: The battery is supplied partially charged. To ensure full battery capacity, fully charge
the battery in the charger before using your power tool for the first time.
The lithium-ion battery can be charged at any time without reducing its service life.
Interrupting the charging process does not damage the battery.
The lithium-ion battery is protected against deep discharge by the „Electronic Cell Protection
(ECP)". When the battery is discharged, the power tool is switched off by means of a
protective circuit: The application tool no longer rotates.
6.2.2. Removing the Battery
The battery is equipped with two locking levels to prevent the battery from falling out when
pushing the battery release button unintentionally. As long as the battery is inserted in the
power tool, it is held in position by means of a spring. To remove the battery, press the
release button and pull the battery back and out of the power tool. Do not use force to do
this.
EN
Operating manual
13

Publicidad

loading