MADER CG432U-KA Manual De Instrucciones página 47

INSTALLATION OF THE 3 TOOTH BLADE
Always wear gloves when touching the blade

Lay the brush cutter on its back with the gearbox shaft facing up.

Rotate the gearbox shaft until the hole in the holder A lines up with the hole in the gear box (Fig 3).

Insert the bar wrench into the hole in the gearbox and into holder A (Fig 3).

Place the 3 tooth blade on the holder A, centering the blade on the raised centre (Fig 5).
Fig 5
RAISED CENTRE

Fit the holder B (Fig 6) and then the safety cover.

Screw the nut anti-clockwise (turn left) and tighten using the spanner provided (Fig 7).

Make sure that the blade is completely and safely locked in position, and there is no space between the
blade and the blade holders.

Remove the bar wrench.
Fig 7 SPANNER
THE BLADE MUST BE CORRECTLY POSITIONED OTHERWISE SERIOUS DAMAGE AND
INJURY TO PERSONS AND PROPERTY COULD RESULT.
HOLDER B Fig 6
HOLDER B
5（GB）
SAFETY COVER