Publicidad
Idiomas disponibles
Idiomas disponibles
FUEL STORAGE
Mixed two-stroke fuel which has been left unused for a period of one month or more may damage the
carburettor and result in the engine failing to start or operate correctly.
When storing the brush cutter for a period of more than one month, empty the fuel tank, and run the
engine to empty the carburettor of fuel.
Two-stroke fuel can cause deterioration of rubber and/or plastic components during prolonged storage.
It is important to only use good quality, fresh fuel mix.
FUELLING
Shake the fuel container to thoroughly mix the two-stroke oil and petrol.
Clean dirt from around the fuel cap before removing.
Pour two-stroke fuel into the fuel tank with a filtered funnel, up to 80% of the fuel tanks capacity.
Replace the fuel cap and tighten securely. Spilled fuel must be wiped away from the brush cutter
before starting the engine.
Move at least 5m away from the refuelling area before restarting the engine.
When refilling the tank, always turn off the engine and allow it to cool down. Take a
careful look around to make sure that there are no sparks or naked flames anywhere
nearby before refuelling.
OPERATION
Keep clear of the cutting head as it may start moving when engine starts.
STARTING THE ENGINE
CAUTION do not pull the starter cord all the way out and do not let go of the starter handle when the cord
is extended, this can damage the starter mechanism.
1. CG432U-KA Model
COLD ENGINE STARTING
Rest the unit on a flat, firm surface. Keep the cutting head off the ground and clear of surrounding objects
as it may start moving when starting the engine.
Push the air purge bulb a Fig 12 until fuel is visible in the clear return fuel line.
Set the ignition switch Fig 15B to the START (I) position.
Push down the enrichment lever to switch to the "starting" position (Fig 13B).
Pull the starter rope until the engine starts.
Briefly squeeze the throttle to switch the enrichment lever to "run" position (Fig 13A, then release the
throttle lever to let the engine idle
Allow the engine to warm up before use.
NOTE:
When the engine is already warm, do not turn the enrichment lever to "starting" position when
restarting the engine.
10（GB）
Publicidad
