Publicidad
Idiomas disponibles
Idiomas disponibles
Congratulations! With your purchase you
have decided on a high-quality product. Get to
know the product before you start to use it.
Carefully read the following assembly instruc-
tions for use. Use the product only as described
and only for the given areas of application.
Keep these instructions safe.
When passing the product on to a third party,
always make sure that the documentation is
included.
Scope of delivery
1 x Paddling pool with three air chambers and
three safety valves
1 x Repair patch
1 x Instructions for use
Technical data
Dimensions: inflated approx. 62 x 23cm
Intended use
This product is intended for private household
use indoors and outdoors.
Symbols used
WARNING!
Observe the symbols on the product before
using the product.
Attention! Never leave children unattended –
risk of drowning!
Safety notices
Risk of injury!
WARNING!
Suffocation hazard for children! Do not allow
children to play with the packaging material or
product whilst unattended.
10
GB/MT
ATTENTION!
Never leave your child unattended– risk of
drowning!
ATTENTION!
Children can drown even in small amounts of
water. Drain the pool when not in use.
• Only adults may inflate and deflate the
product.
• Check the product for damage or wear
before every use. Only use the product in
sound condition! Do not use the product if
damage is visible or suspected.
• Do not use the product if air is leaking.
Prevent property damage!
• All inflatable products are sensitive to the
cold. Therefore never unfold and inflate the
product in temperatures below 15 °C!
• If the air pressure increases in the blazing sun,
this product must be adjusted accordingly by
deflating.
• Be sure the product – particularly whilst in-
flated – does not come into contact with
stones, pebbles or pointy objects and does
not rub or grind against anything, as the film
may otherwise be damaged.
• The product should be set up at least 2m
from other structures or objects, e.g. fence,
garage, house, overhanging branches,
washing lines or electrical lines.
• Only insert suitable pump adapters into the
safety valves. The valves may otherwise be
damaged.
• Do not overinflate, as the seams may other-
wise tear. Close valves tightly after inflating.
• Avoid contact with sharp, hot, pointy or dan-
gerous objects.
• Never set up the product on concrete, asphalt
or other hard surfaces.
• Be sure to equally and successively fill the
chambers with air.
• Never inflate the air chambers until they feel
hard. When pressing the respective air cham-
ber with your thumb it should still have slight
give.
Publicidad
