Assa Abloy SW200 Manual De Usuario página 9

How the ASSA ABLOY SW200 works
The swing door operator ASSA ABLOY SW200 uses a DC motor which is connected to the output
shaft by a combination of a bevel gear and spur gears. The arm system that is connected to the output
shaft opens the door in a wall mounted application.
There is also an adjustable spring mechanism connected to the output shaft. During opening of the
door, the clock spring is tensioned by the rotation of the output shaft. During the closing cycle, the
accumulated spring force is acting in the closing direction. The spring force can be adjusted so there
is appropriate force to close the door when it is operated manually or in case of a power failure.
To activate the operator you can use a manual activator (elbow switch) or an automatic activator
(radar device). It is also possible – where local standards allow – to activate the operator by just
pushing the door, if Push & Go is selected.
After the door has been activated it will open and stay open for a specified Hold Open Time (HOT).
When the HOT has elapsed the door will close.
The ASSA ABLOY SW200 can be set in three or four different modes, depending on optional pro-
gramme selector type, see table below.
In fully manual use (or in case of a power failure) the ASSA ABLOY SW200 acts as a normal door
closer.
Position Function
OFF The door is closed. The door cannot be opened with inner and outer activation
units. The door is locked if an electromechanical locking device has been fitted.
The door can be opened with a key switch (if fitted).
EXIT Passage from inside only. The door is normally locked if an electromechanical
locking device has been fitted. The door can only be opened with the inner activ-
ation unit and with a key switch (if fitted).
AUTO The door can be opened with the inner and outer manual and/or automatic ac-
Normal tivators. The electric strike, if fitted, is open.
position
OPEN The door is held permanently open by the motor.
ASSA ABLOY SW200 Variations
ASSA ABLOY SW200 -SA-
152X152:
ASSA ABLOY SW200 -OHC:
1009952-multi-9.0
Surface applied application in 152 mm wide x 152 mm high header
OHC application in 152 mm wide x 152 mm high header
Issue 2021-05-25
EI
9