Publicidad
Idiomas disponibles
Idiomas disponibles
1
2
3 4 5 6 7
REAR PANEL
1
1.- AUX 1/AUX 2: stereo auxiliary inputs for connection of audio devices such as mixers, computers, etc.
These inputs have 2 connector options, 2xRCA or euroblock.
2.- CH 2/CH 3/CH 4: audio inputs from dynamic microphone (MIC), condenser microphone (PHANTOM 48
V) or lines (LINE), balanced eurolock connector. Once the input type has been selected with the MIC/
PHANTOM 48 V/LINE selector, the gain of the input can be adjusted with the GAIN control..
3.- CH 1 - PAGING MIC: priority audio input for dynamic microphone (MIC), condenser microphone
(PHANTOM 48 V) or lines (LINE), balanced combo connectors (XLR and 6.3 mm jack) and eurolock.
Once the input type has been selected with the MIC/PHANTOM 48 V/LINE selector, the gain of the
input can be adjusted with the GAIN control.
4.- VOX CH 1 - CH 4 : setting the sensitivity to make the CH 1-4 inputs priority over all other signals.
Depending on this setting, the signal level required at the CH 1-4 inputs to cut audio from other sources
will be higher or lower. If the VOX control is set to minimum, no audio will be cut off from any output
when there is signal on CH 1-4. Please note the order of priority of the amplifier inputs, for more
information see section CONNECTION - PRIORITY OF INPUTS.
5.- EMERGENCY INPUT: 100 V audio input for connecting an emergency system, euroblock.
6.- BASS: boosts/attenuates low frequencies.
7.- TREBLE: boosts or attenuates high frequencies.
8.- REMOTE MUTE: mute/unmute the speaker output remotely with the help of a switch, euroblock
connector. This input is in open circuit, to silence it you must close the circuit.
9.- LINE OUTPUT: line output, 2xRCA connectors.
10.- SPEAKER OUTPUT 240 W RMS: 4 Ω low impedance speaker output and 240 W RMS 100 V, threaded
connectors. Please note that the choice of low impedance speakers must conform to the amplifier
specifications for serial or parallel connection (only parallel for 100 V line) to obtain power and impedance
appropriate to the amplifier output.
11.- ANTENNA - FM: input for connection of an FM antenna.
12.- ANTENNA - BLUETOOTH
13.- ZONE OUTPUT (100 V): 100 V line speaker output of 240 W RMS maximum to be shared between
the 2 zones. It is possible to connect 1 single zone and use the 120 W RMS provided by the amplifier,
threaded connectors. Please note that the choice of low impedance speakers must conform to the
amplifier specifications for serial or parallel connection to obtain power and impedance appropriate to
the amplifier output.
14.- 115/230 V amplifier power supply input.
15.- AC SELECT: power supply voltage selector. If you need to change the voltage you should be aware
that the fuse must be modified as specified on the product.
8
2
3 4
5
: Bluetooth
signal antenna.
®
®
9
6
7
8
9
10
11
12
- 3 -
10
11
13
14 15
PROX-240Z
PA AMPLIFIER
~230 V AC, 50/60 Hz, FUSE: T4 A
~115 V AC, 50/60 Hz, FUSE: T8 A
POWER CONSUMPTION: 480 W
12
131415
EN
Publicidad
