Schumacher Electric MC-1 Manual Del Usuario página 7

USING THE QUICK-CONNECT CABLE CONNECTORS
Connect either of the two (2) output cable leads to the charger in a matter
of seconds.
WARNING: Never connect the clamp and ring terminal connectors together
for use in other applications, such as external battery or other power source
charging, or to extend the output cable length, as reverse polarity and/or
overcharge conditions will occur.
BATTERY CLAMP QUICK-CONNECT
1. Connect the end of the charger output cable to the end of the battery
cable, quick-connect and clamps.
2. Follow the steps in sections CHARGING A BATTERY IN THE VEHICLE
and CHARGING A BATTERY OUTSIDE OF THE VEHICLE to connect
the output clamps to the battery.
3. Connect the charger to an electrical power outlet.
RING CONNECTOR QUICK-CONNECT
1. To permanently attach to a battery, loosen and remove each nut from the
bolt at the battery terminal.
2. Connect the red POSITIVE connector ring to the POSITIVE battery terminal.
3. Connect the black NEGATIVE connector ring to the NEGATIVE battery
terminal.
4. Replace and tighten the nuts to secure.
5. Connect the cable to the end of the charger output cord.
Take care to keep the wires and plug away from metal and moving parts.
6. Connect the charger to an electrical power outlet.
MANUAL CHARGING MODE
When a manual charge is performed, the charger will continue to charge and
will not shut off. Be sure to monitor the charging process and stop it when the
battery is charged. Not doing so may damage your battery or result in other
property damage or personal injury.
This charger has a rated output of 1 amp, with an expected finish rate of 0.3 amps.
These outputs will vary with the age and condition of the battery being charged.
WARNING: This is a manual battery charger. Charging must be monitored to
prevent overcharging. Overcharging a battery could cause personal injury and/
or property damage.
Use the following table to more accurately determine the time it will take to
bring a battery to full charge.
Ah – Ampere Hours CCA – Cold Cranking Amps
The times given are for batteries with a 50% charge prior to recharging. Add
more time for severely discharged batteries.
CALCULATING CHARGE TIME
• 7 •
RC – Reserve Capacity