Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY AND OPERATION
APPLICATIONS
Illumination of work site
REMOVAL AND INSTALLATION
METHOD OF BATTERY
○
How to install the battery.
Always insert it all the way until it locks in place
with a little click. (Fig. 5-a).
a
b
○
How to remove the battery.
While pressing the 2 latches (one on each
side), slide it and pull it out. (Fig. 5-b).
NOTE
If any water or dust enters the body of the tool
or the terminals of the battery, a failure may
occur.
Latches
(Both sides)
Battery
(sold separately)
Fig. 5
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure
the following points.
○
The power source voltage is stated on the
nameplate.
○
The cord is not damaged.
WARNING
Do not charge at voltage higher than
indicated on the nameplate.
If charged at voltage higher than indicated
on the nameplate, the charger will burn
out.
1.
Connect the charger's power cord to a
receptacle. When the power cord is connected,
the charge indicator lamp will blink in red. (At
1-second intervals)
WARNING
Do not use the electrical
cord if damaged. Have it
repaired immediately.
2.
Insert the battery to the battery charger.
Firmly Insert the battery into the battery charger
as shown in Fig. 6.
Pilot lamp
English
Battery
Guide rail
Fig. 6
11
Publicidad
