Echo Pro Attachment Serie Manual Del Operario página 27

DPAS-2100
Problem
The line does Lines are welded to
not advance. themselves.
Not enough line on
spool.
Lines are worn too
short.
Lines are tangled on
spool.
The line The machine is used
keeps break- incorrectly.
ing.
Grass winds Cut tall grass at ground
around the level.
trimmer head
and motor
housing.
The line does The cut-off knife
not cut well. becomes dull.
Heavy The length of line on
vibration. one side is longer than
the other side.
99922205734
© 08/2021 ECHO Incorporated
Possible Cause
TROUBLESHOOTING
Solution
Lubricate with silicone spray.
Install more line.
Advance the cutting line.
1. Remove the lines from the spool.
2. Wind the lines.
1. Cut with the tip of the line, avoid
stones, walls and other hard objects.
2. Advance the cutting line regularly to
keep full cutting width.
1. Cut tall grass from the top down.
2. Remove no more than 8" in each
pass to prevent wrapping.
Sharpen the cut-off knife with a file or
replace it.
Make sure that the line on both sides
is equal in length. Advance the line.
27