Descargar Imprimir esta página

Directed RF KIT Manual De Instrucciones página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

Remote Pairing
Note: If this product is being used with an older Directed sys-
tem, once the control center is connected, make sure the system
is disarmed and the control center LED is completely off for a
minimum of 60 seconds prior to beginning the remote pairing
process.
Prepare the vehicle system to be Paired with a remote control
1.
Open at least one vehicle door.
2.
Turn the key to the ON position.
Within 5 seconds press and release the Control button on
3.
the Control Center one time.
Within 5 seconds, press and hold the Control button on the
4.
Control Center. The status LED begins flashing in single flash
sequence and the siren/horn sounds once to confirm the
system is ready for remote pairing. Release the button.
5.
Locate your remote control type following this section and
proceed with the instructions.
System Pairing will exit if:
The ignition is turned off
The open door is closed
60 seconds lapses with no actions
Note
: Make sure the remote to be paired with the system is set for
the desired Car 1 or Car 2 operation.
LCD Remote Control:
1.
Press and hold the
once, Main Menu
Press the AUX or
2.
4
AUX
button for 8 seconds, the remote beeps
is displayed. Release the
buttons until
AUX
Pair is displayed.
© 2013 Directed. All rights reserved.
AUX
button.

Publicidad

loading