Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS
1.
Neck and back warmer
2.
Cable connection
3.
Neck fastening
4.
Waist fastening
5.
Control panel
6.
On/off button
7.
Increase heat setting
8.
Decrease heat setting
9.
Display
2
BEFORE THE FIRST USE
Remove all packaging materials and any promotional stickers.
·
Never use the device when folded, bent, turned down, and/or tucked in.
·
Do not place artificial heat sources, or heavy and/or angular objects on the device.
·
The device is equipped with overheating protection. This protection prevents the device from
·
overheating across its entire surface by automatically switching off the power in the event of a
malfunction. Please note that the device may not be used afterwards for safety reasons and must be
returned to your retailer.
There may be a slight odour from the device when it is used for the first time. This is normal. It is
·
recommended that the room be ventilated briefly after the first use.
USE
1.
Click the cable into the cable connector on the neck and back warmer and plug the other end into
the electrical socket.
2.
Lay the neck and back warmer over your shoulders, close the neck fastener using the snaps, and tie
the belt around your waist. Make sure that the cable connector is located on the outside of the neck
and back warmer.
3.
Press the on/off button to switch on the appliance. "1" will appear on the display.
1
4.
Then press the button to increase the heat setting. Each press of the button will increase the
temperature. Use the button to lower the heat setting to decrease the temperature again. You
can choose between 9 heat settings (1-9). We recommend starting on a low setting and gradually
www.domo-elektro.be
3
2
1
9
7
8
4
3
5
6
27
DO636K
Publicidad
