Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
If your Mission
does not work correctly, follow the trouble shooting guide below. If the fault persists, contact
TM
your dealer.
Symptom
The LED light on the charging
base does not turn on.
Red light turns on the charging
base.
Your Mission
is inside its
TM
working area but the display
says "outside working area"
and the LED is green.
Mission
cannot correctly
TM
dock with the Charging base.
Mission
runs outside the
TM
boundary wire. Mission
not mow an area within a
boundary wire zone. Mission
reverses or rotates erratically
near the boundary wire.
Mission
exits the boundary
TM
wire due to high speed when
going down a hill.
Environmental protection
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Cause
There is no power.
The boundary wire isn't
connected.
The boundary wire ends are
clamped incorrectly.
Environmental influences.
Poor connection caused by
debris on the charging strip.
The boundary wire of another
Mission
or another branded
TM
robotic mower is positioned too
closely.
The boundary wire has been
installed with acute angles.
does
In wet conditions, the boundary
TM
wire electric signal may leak
where wire has been joined or
TM
repaired.
There is boundary wire electric
signal leakage due to broken
insulation.
The cutting area is larger than
the allowable cutting area for
Mission
.
TM
The boundary wire is placed on
a slope steeper than 17% (10°).
Solution
Check the charging base is connected
properly to the charger and the charger
is connected to a suitable power supply.
Check that the boundary wire has been
connected correctly to the charging base.
Check there are no breaks in the
boundary wire, especially in the wire ends.
Reverse the boundary wire ends.
Restart Mission
.
TM
Clean the contact pins located on the
charging base and the charging strip on
Mission
using a cloth.
TM
Ensure your Mission
boundary wire
TM
has at least 1m of spacing between the
neighboring boundary wire.
Check the boundary wire to ensure the
angles are smooth.
Check boundary wire joints. Insulate to
provide a fully waterproof connection.
Repair damaged boundary wire
insulation with insulation tape.
Decrease the cutting area.
Reposition the boundary wire away from
slopes that are steeper than 17% (10°).
13
EN
Publicidad
