nania D11 Manual De Instrucciones página 20

All manuals and user guides at all-guides.com
Fitting the harness
Put the harness shoulder straps in one of the two positions indicated (15) so that they
always pass over your child's shoulders (see paragraph on "Adjusting the harness").
To tighten the harness: Pull on the adjusting straps positioned on the harness. You do
not need to press on the adjuster buttons (16).
IMPORTANT: A poorly fitting harness can be dangerous. You should not be able to
insert two fingers between the shoulder strap and your child's chest.
To loosen the harness: Press on the adjuster buttons positioned on the upper section
of the harness, grasp the lower section and pull simultaneously (17).
Adjusting the harness
Make sure that the harness of your car seat is adapted to the height of your child before
starting to install the seat in your car.
The harness can be adjusted to two different heights. The straps must pass through the
holes that are closest to your child's shoulders. If your child's shoulders are between
two levels, always use the higher of the two.
To adjust the height of the harness, remove the upper section of one of the harness
straps by twisting the metal keeper located behind the backrest and then pulling the
end of the harness strap through the slots of the shell and the cover (18). Feed the end
of the harness strap through the same slots at the desired height, both in the cover and
the shell and reattach it behind the backrest (19). Make sure that the metal anchor is
correctly positioned and that the harness strap is not twisted. Repeat the opera-
tion on the second strap.
Inclining the ISOFIX Car Seat
Push the adjustment lever located under the front of the seat upwards, then pull or
push the base towards or away from you (20).
Adjustable head support
(optional according to model)
Loosen the wheel on the head support (21), adjust the head support to the desired
height (22), then tighten the wheel (23).
Removing the ISOFIX Car Seat
Loosen the Top Tether Strap by pulling on the tensioner to tilt it (24) then release the
strap from its anchor point and bring the strap towards you (25). Pull the car seat using
the red handle on the ISOFIX base (26). On either side of the seat, release the ISOFIX
connectors from their anchor points by pulling the release buttons on the connectors
towards you. The indicators will turn from green to red (27) (28). The seat is now unat-
tached and can be removed from the rear side (29).
Storage of the instruction manual
Always read the safety instructions. Read these instructions carefully before use and
keep them to hand in the pocket provided for future reference (30).
20
User guide