NordicTrack TRAPMASTER Manual Original página 8

3 Charging
Use only the charger listed in section "Electrical power supply" or one with identical specifications.
If the Indicator LED (2) emits no light at all, after switching the TrapMaster on, then the battery is empty and needs to be charged.
When the light is red the capacity of the battery is lower than 33%. The light must be either green, yellow or red for the TrapMas-
ter to be ready and functional.
To charge the TrapMaster:
•
Remove the protection socket (4)
•
Plug in the small plug of the charger
•
Connect the charger to the wall plug
•
Check the red Charging LED (5) lights up which indicates it is charging
•
Let the charging continue until the Charging LED turns off, indicating the charging has completed.
•
Unplug the charger from the wall plug and then from the TrapMaster
•
Put the protection socket back into the plug (4)
The TrapMaster should always be switched off, while charging.
During charging, avoid covering the battery charger or the battery part of the TrapMaster below the handle, and ensure good ven-
tilation.
4 Operation
Machine operation must comply with the intended use of the machine. See section 2.4 Intended use.
4.1
Risks and hazards
All users must have gone through all safety aspects described in section 1 Safety before operating the machine for the first time.
4.2
Controls
The TrapMaster is manually controlled by the power switch (1), the stepwise power regulator (6), blue load button to lock the
clay(s) (8) and the red fire button (9). The numbers refer to section 2.6 TrapMaster features.
4.3
Operating modes
•
Manual operation: The user fixes a clay(s) at the shaft (7) by activating the blue load button (8) and launch it by pushing the
red fire button (9). This is done repeatedly. The numbers refer to section 2.6 TrapMaster features.
•
Charging: The user charges the integral rechargeable battery by using the included battery charger.
4.4
Starting
Each time you start using TrapMaster after it has been put aside even for a short time you must check the power switch for use as
an emergency stop. How to do it, see section 5 "Inspection and testing of the TrapMaster."
Before using the TrapMaster, the user must also ensure that:
•
There is sound footing
•
There is a clear view of 40 degrees to the left and to the right of the aiming direction
•
There is no people located within the aforementioned angles.
4.5
Mounting and launching a clay(s)
•
Take a new clay(s) (11).
•
Check the clay(s) is undamaged and intact, if not, discard it and take another one.
•
Switch on the TrapMaster on the power switch (1).
•
Wait until the Indicator LED (2) turns on and has played its start-up sound.
o
Three fast beeps and one long.
•
While holding the TrapMaster in your hand tilt the TrapMaster 90º backwards, so the shaft (7) is pointed towards the
sky and is horizontal.
www.nordicclays.com/quickstart
8