NordicTrack TRAPMASTER Manual Original página 9

•
Place the clay on the Shaft (7) so the clay(s) rests on the stop.
•
Push the blue load button (8) to lock the clay(s) onto the shaft.
o
Should you by mistake push the button, before placing the clay(s). Then push and hold the button till
you've placed the clay(s) on the shaft.
•
Notice the short little sound and the clay(s) is/are locked to the shaft.
•
Check again the footing and that no people are located within the hazardous areas.
•
Push the red fire button (9), the clay starts accelerating leaving the TrapMaster 2-3 seconds later.
•
When the shafts rotation has stopped, the TrapMaster is ready for a new clay(s) and you may repeat the procedure or
switch it off on the power switch (1).
4.6
Emergency situations
Dangerous situations may occur during use where it is necessary to make an immediate stop of the TrapMaster. If such a situa-
tion occurs, switch it off on the power switch (1).
Following situation may require emergency stop of the TrapMaster:
•
A dangerous situation
•
The occurrence of sudden unknown conditions, e.g., abnormal noises (rumbling, knocking, sizzling), vibrations or heat. In
this case the user must inspect the TrapMaster for faults and defects before turning it on again.
4.7
Removal of waste from operation
After having shot one or multiple clays, always make sure to take your trash with you, so you leave the nature as when you ar-
rived.
4.8
Transportation
Always use the suitcase delivered with the TrapMaster when you transport or store the TrapMaster.
The integral Li-Ion battery is subject to the Dangerous Goods Legislation requirements. The battery is suitable for road-transport
by the user without further restrictions.
When shipping by third parties (e.g.: by air transport or parcel post), special requirements on packaging and labelling must be
observed. For preparation of the item consult the company, you intend to use. Be aware of the possibility of more detailed national
regulations.
5 Maintenance and service
There are no user-replaceable parts.
Inspection and testing of the TrapMaster
Component/
Frequency:
machine part:
The power switch Each time
for use as emer- TrapMaster
gency stop. has been put
aside even for
a short time
and at least
once a year.
How (method):
non-acceptance:
Safety relevant inspection and testing:
Follow the instruction The motor must stop
in section "Mounting
immediately.
and launching a
clay(s)", but without a
clay. Within 1 second
after the motor starts
switch off the ma-
chine on the power
switch.
www.nordicclays.com/quickstart
Acceptance/
Action:
In the event of a
failure, the Trap-
Master must be
repaired, after
which the function
must be tested
again.
I/T/M
I = Inspection,
T = Testing.
M = Measuring
I/T
9