Mac allister MPWP2700 Manual De Instrucciones página 36

Troubleshooting
EN EN
Troubleshooting
Problem
4. Strong
pressure
fluctuation
5. Water leakage
from product
6. Excessive
vibration/noise
7. No detergent
taken in
8. No water jet
36
MNL_MAC_GB_High pressure cleaner_MPWP2700_V5_200528.indd 36
Possible cause
4.1. Nozzle clogged
4.2. Water inlet volume is
too low
4.3. High-pressure hose
is leaking
4.4. Seals worn
4.5. Intake filter dirt
4.6. Air being sucked into
the system
5.1. Seals worn
6.1. Screws and nuts
loosened
6.2 Motor problems
6.3 Water inlet volume is
too low
7.1. Soap tank not
attached
7.2 Detergent too dense
7.3 Deposits or restriction
in detergent circuit
8.1. Trigger is not
squeezed
8.2 Trigger lock is
activated
8.3 No water supply
8.4 Filter is dirty
8.5 Hose blocked
8.6 Nozzle blocked
MPWP2700 by MacAllister
Solution
4.1. Clean the nozzle
4.2. Increase water inlet
quantity
4.3. Replace high-pressure
hose
4.4. Contact our nearest
authorised service
centre
4.5. Clean the filte
4.6. Check thickness of hose
fitting
5.1. Contact your nearest
authorised service
centre
6.1. Check screws and nuts
for tightness and re-
tighten as necessary
6.2 Contact your nearest
authorised service
centre
6.3 Increase water inlet
quantity
7.1. Attach the soap tank
7.2 Dilute with water
7.3 Flush with clean
water and eliminate
any restrictions. If
the problem persists,
contact an authorised
service centre
8.1. Squeeze the trigger
8.2 Deactivate the trigger
lock
8.3 Check water supply
8.4 Clean filter
8.5 Check hose
8.6 Check nozzle
5/28/20 8:31 AM