Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING AND STORING YOUR AERONEB
AFTER EVERY USE:
Disconnect the control module before you take the nebulizer
apart to rinse it.
1. Rinse the Nebulizer Unit (Medication Cup, Nebulizer
Body, Base and Mouthpiece or Mask Adapter) under
running hot tap water after every use.
2. Shake off excess water, and allow parts to fully air dry on
a clean, dry towel, out of the reach of children.
3. Make certain that all cleaned parts are completely dry
before you store or use them.
DAILY:
Disconnect the power source before you take the nebulizer
apart to clean it.
1. Wash the Nebulizer Unit (Medication Cup and Cap,
Nebulizer Body, Base and Mouthpiece or Mask Adapter)
by hand in a solution of warm water and mild liquid
dishwashing soap. Use soap intended only for washing
dishes by hand. Do not use dishwasher detergent. Do not
leave parts soaking.
2. Rinse all pieces thoroughly under running hot tap water.
Make sure that no soap is left on any of the parts.
3. Shake off excess water, and allow parts to fully air dry on
a clean, dry towel, out of the reach of children.
4. Make certain that all cleaned parts are completely dry
before you store or use them.
GO
®
11
Publicidad
