Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING GUIDE
If you have difficulty operating your Aeroneb
following points:
Problem
No visible
aerosol
when using
batteries
No visible
aerosol when
using AC/DC
adapter
14
Check
Check that the
batteries are
inserted correctly.
Check to see if the
low battery power
light is flashing.
Check that the
Control Module
cable is connected
properly to the
nebulizer and to the
Control Module.
Check that the
AC/DC Adapter is
plugged correctly
into a working AC
outlet and the green
light is on the AC/DC
Adapter.
Check that the
AC/DC Adapter
cable is connected
properly to the
Control Module.
Go, check the
®
Remedy
Using the markings
under each battery
location, place
each battery in the
Control Module
housing. Match (+)
and (-).
Replace the
batteries or use the
AC/DC Adapter.
Connect the cable
properly to the
nebulizer and the
Control Module
(Refer to page 8).
Insert the plug into
a working outlet
and verify that the
green light on the
controller is lit (Refer
to page 10).
Connect the
AC/DC Adapter
cable properly to
the Control Module
(Refer to page 10).
Publicidad
