Stealth Products MTHW-620 Manual De Usuario página 6

Installation
Abductor Pad (Pommel) Installation
Applies to the following abductors:
MTMD-12 (S)
MTMD-13 (M)
MTMD-14 (L)
MTMD-19 (CUSTOM)
Fixed Mount Installation
Applies to the following hardware:
MTHW-620
1
MTMD-21 (XS)
MTMD-22 (S)
MTMD-23 (M)
MTMD-24 (L)
MTMD-29 (CUSTOM)
Your Medial Thigh Support may have been pre-
assembled from the factory. If this is not the case,
please follow the instructions below. Installation of
the pad is the same for all models of support
hardware.
Select the proper orientation and mounting holes in
the abductor pad for the position required. Insert the
included button head cap screws through the slot in
the adjustable riser of the medial support hardware
and into the mounting holes in the pommel.
Tighten the screws sufficiently to secure the pad.
Do not overtighten the screws.
MTHW-640
MTMD-32 (S)
MTMD-33 (M)
MTMD-34 (L)
MTMD-39 (CUSTOM)
MTHW-650
Mounting the fixed hardware:
1. Locate the t-nuts in the bottom of the
seat.
2. Line up the slots in the fixed bracket with
the two corresponding rows of t-nuts in
the bottom of the seat.
3. Insert the two 1/4-20 x 3/4" Button Head
Screws into the designated holes and
tighten with a 3/16" hex key.
MTMD-41 (S)
MTMD-42 (M)
MTMD-43 (L)
MTHW-660
EN