4
5
NOTE: The installation methods take the PoE camera as an example and
also apply to the WiFi camera.
11
English
Loosen the two screws on both
sides of the camera and adjust
the camera viewing angle.
Tighten the screws and screw the
cover back to the camera.
Troubleshooting
Camera is not Powering on
If your camera is not powering on, please try the following solutions:
For PoE Camera
• Make sure your camera is powered on properly. The PoE camera should
be powered by a PoE switch/injector, a Reolink NVR or a 12V power
adapter.
• If the camera is connected to a PoE device as listed above, connect it to
another PoE port and check again.
• Try again with another Ethernet cable.
For WiFi Camera
• Plug the camera into a different outlet and see if it works.
• Power on the camera with another working 12V 1A DC adapter and see
if it works.
If these won't work, contact Reolink Support.
English
12