Publicidad
Idiomas disponibles
Idiomas disponibles
(on streets, water springs, landfills, etc.).
Schulz recommends that the waste resulting from the product, from its generation, use, transportation, and
treatment to its final disposal shall be handled carefully.
Proper handling should consider the following stages: quantification, qualification, classification, reduction at
source, pick-up and selective pick-up, recycling, storage, transportation, treatment and final destination.
Waste disposal should be done in compliance with the requirements of local legislation in effect.
Wastewater Disposal
The presence of wastewater or non-treated condensate from the tank or condensate separator in rivers, lakes
or in other water receiving bodies may adversely affect the aquatic life and the water quality. Therefore, Schulz
recommends treating wastewater properly, according to the provisions of local legislation in force. The conden-
sate withdrawn daily from the tank or condensate separator, according to the chapter "Preventive Maintenance",
must be kept in a container and/or in an appropriate collecting network for further treatment. Schulz sells Water
and Oil Separators that can help to treat this type of waste.
12. FAILURE DIAGNOSTICS
Many times, what, at first time, seems to be a defect can be solved by you without the need of a SCHULZ AU-
THORIZED DEALER. assistance. If the problem persists after performing the corrective actions below, contact the
nearest SCHULZ AUTHORIZED DEALER.
PROBLEM
The water jet is not consistent.
The motor does not start or stops
suddenly.
The motor works, but the water
jet is weak.
13. TERMS OF WARRANTY
SCHULZ COMPRESSORES LTDA., within the limits of this Term, assures the first buyer/ user of this
product the warranty against manufacturing defects for a period of 1 (one) year (including the Legal
Warranty – first 90 (ninety) days), counting from the invoice date.
Components such as Schulz kits and accessories, when accompanied by the product or purchased
separately, are warranted against any manufacturing defects for a period of 90 (ninety) days, from the
date of issuing the sales invoice.
WARRANTY GENERAL CONDITIONS
A.
Warranty reception will only be held in view of presentation of the original invoice, preferably on behalf of
the customer, containing data of personal documents or business documents.
B.
Any warranty service must be performed solely and exclusively by SCHULZ AUTHORIZED DEALER.
C.
It is not included in the warranty: parts that naturally wear out with regular use and that are influenced by installa-
tion and way of use of the product, such as: hose, wheels, power cord, nozzle, trigger gun, moving handle, on/off
button, capacitor, accessories, water filter, pistons, springs, seals, valves, bearings, extension gun, nozzles, motor
brushes and motor. Components which when being in the product. Only in the cases in which the CUSTOMER SER-
POSSIBLE CAUSE
The nozzle might be blocked.
The thermal protection might have actua-
ted to prevent the motor from overloading
and burning out.
The pump might be sucking in air.
34
POSSIBLE SOLUTION
Clean the nozzle (see item Chapter –
Preventive maintenance.
Turn and keep the pressure washer off for
around 5 minutes, so that the temperature
drops to normal values.
Check if the water inlet hose is well
connected and if the flow is within the
specified values Fully open the Water inlet
flow regulator valve.
Publicidad
